T Post vs Wooden Post: Cost, Life and Where Each Wins

2026-11-17 08:31:44 1 0

A T post vs wooden post decision is usually made on the price of one post, and that is the wrong unit to compare. Steel and timber differ in weight, in how they are installed, in what happens when they are hit by stock or machinery, and in how long they last before the line has to be rebuilt. This comparison puts both posts on the same basis - cost per metre of finished fence and service life - so the cheaper post on the invoice is not automatically the cheaper fence.

The Two Posts in Numbers

Galvanized Steel T Post

A studded T post runs about 2.23 kg/m in the 1.5 lb section and about 2.04 kg/m in the lighter section. A 1.8 m length weighs 4.01 kg and a 2.1 m length 4.68 kg at 2.23 kg/m, so a bundle of 50 posts is a two-person lift, not a crane job. The section is thin-walled, which is why it drives well and why it bends rather than snaps under a heavy impact.

Timber Post

A treated timber post of the same height is far heavier and carries a much larger footprint in the ground. It resists pull-out through mass and soil contact rather than through driven grip, which changes how the fence behaves at corners and in wet ground.

Cost Per Metre, Not Per Post

The only fair comparison is cost per metre of finished fence. At 3 m centres a 100 m run needs 34 posts, so the post price is multiplied by 34 before anything else is counted, then posts, fixings, labour and the share of strainers and braces at the ends are added. Two posts that differ by a small amount per unit can differ by a large amount over a kilometre, and the labour line usually decides the result: driving a steel post takes a fraction of the time needed to dig a hole, set a timber post and backfill it.

Installation: Driving Against Digging

Steel

A T post is driven with a driver or a post hammer, and the line goes up quickly on open ground. The limit is ground condition: rock or compacted gravel stops a driven post, and in loose sand a driven post needs extra depth to hold.

Timber

A timber post needs a hole, a footing and time. That works in favour of timber on small runs, on sites where a driver cannot reach, and where the ground is too stony to drive into. On a long boundary the digging time is the cost that steel avoids.

Service Life

Both posts depend on their protection, not on the material name. A hot dip galvanized steel post in a well-drained line holds its section for many years; the same post with a thin coating and cut ends left bare rusts from the base up. Timber life depends on species and treatment quality, and on whether the post sits in wet ground; a poorly treated post in a wet hollow can go soft well before the fence line is due for replacement. Ask for coating mass on steel and treatment details on timber rather than accepting a generic "long life" claim.

Damage, Repair and Replacement

Steel bends and can often be straightened or replaced post by post without disturbing the wire line. Timber cracks, rots and eventually snaps at the ground line, and a failed timber post usually disturbs the wire and the neighbouring posts. On a line exposed to machinery, the replace-one-post cost of steel is the argument that shows up a few years after installation.

Where Each Post Wins

Steel Wins

Long boundaries, stock fencing, fast installation, dry or firm ground, and any line where a single post may be hit and needs replacing without redoing the fence.

Timber Wins

Short runs, equestrian and amenity fencing where the look matters, stony ground that cannot be driven, and sites where a heavier post is wanted at a gate or corner without adding a separate brace.

Specification Checklist

For steel, specify section weight in kg/m, length, coating class, the number of posts per bundle and the fixings that match. For timber, specify species, diameter or section, treatment class and the length below ground. In both cases give the line length, post spacing, soil type and destination port - with those points a quote can be built on finished metres rather than on units.

What to Put in the Enquiry

Send post type, kg/m or timber section, length, spacing, quantity, soil condition and destination port. See the 1.5 lb studded T post, the 2.04 kg/m T post, and the full T post range.

FAQ About T Post and Wooden Post

Q: Which is cheaper, steel or timber?

Compare cost per metre of finished fence, not per post. Steel usually wins on long runs because driving is far faster than digging.

Q: How long does a galvanized T post last?

Life depends on coating mass and ground drainage rather than on the post alone; thin coatings and bare cut ends are where corrosion starts.

Q: Can a T post be used for gate posts?

A standard line post is not a gate post. Gates need a heavier section and extra depth or a brace to carry the hinge load.

Q: How many posts does 100 m need?

At 3 m centres, 34 posts for a straight 100 m run, before adding strainers and braces at the ends.

Q: Can posts and fixings be supplied together?

Yes. Send post type, kg/m, length, spacing and destination port to Dutai. WhatsApp / Mobile: +86 158 0311 4155 | Email: sales@cndutai.com or info@studdedtpost.com. Address: Anping City, Hengshui City, Hebei Province, China.